Re: Debian on iomega storcenter ix4-200d: succes!

marcogaio Wrote:
-------------------------------------------------------
> I've had tried 'sata' with no luck, so i think SCS
> I was the correct option. Sorry.
>
> Anyway, same result:
>

> Marvell>> setenv usb_make_boot_args 'setenv bootar
> gs console=ttyS0,115200 mtdparts=orion_nand:$(uboo
> t_size)@$(uboot_start)(uboot),$(env_size)@$(env_st
> art)(env),$(kernel_si
> ze)@$(kernel_start)(zImage),$(initrd_size)@$(initr
> d_start)(initrd),32m@0x0(flash) root=LABEL=rootfs
> rootdelay=10'
> Marvell>> setenv load_initrd 'ext2load ide 0:1 0x1
> 100000 /uInitrd'
> Marvell>> setenv load_uimage 'ext2load ide 0:1 0x8
> 00000 /uImage'
> Marvell>> setenv sata_boot 'ide reset; run load_ui
> mage; run load_initrd; bootm 0x800000 0x1100000'
> Marvell>> setenv bootcmd 'run usb_make_boot_args ;
> run sata_boot; reset'
> Marvell>> boot
>
> Reset IDE:
> Marvell Serial ATA Adapter
> Integrated Sata device found
>
> ** Bad partition 1 **
> ** Bad partition 1 **
> ## Booting image at 00800000 ...
> Image Name:   Linux-4.8.3-kirkwood-tld-1
> Created:      2017-01-31  21:44:30 UTC
> Image Type:   ARM Linux Kernel Image (uncompres
> sed)
> Data Size:    3241844 Bytes =  3.1 MB
> Load Address: 00008000
> Entry Point:  00008000
> Verifying Checksum ... Bad Data CRC
>

>
> Note the 'Bad partition 1' message that does not h
> appen on SCSI...

I see. This is how this stock u-boot was buillt then.

Last question: were you the root user when you tar the rootfs to the HDD? and being root the whole time after that?